With the increasing heat of home decoration, the Nordic Minimalist Lighting changes rapidly, not confined to the previous single lamp, but to a diversified development, not only absorbed the luxury and style of chandeliers, but also adopted a ceiling-style installation, to avoid the shortcomings of smaller rooms can not install large-scale luxury lighting. The LED Nordic Minimalist Lighting Body is mounted directly on the roof, suitable for overall lighting, usually used in the living room and bedroom. Attention should be paid to the following points when installing and using Nordic minimalist lighting.

1. When installing Nordic minimalist lamps in masonry structures, pre-embedded bolts or expansion bolts, nylon plugs or plastic plugs should be used to fix them. Wood wedges should not be used. And the bearing capacity of the fixtures should be matched with the weight of the Nordic Minimalist Lighting to ensure that the Nordic Minimalist Lighting is firmly fixed, reliable and can extend its service life.

2. When fixing with expansion bolts, bolt specifications should be selected according to the technical requirements of the products. The borehole diameter and buried depth should be in accordance with the bolt specifications.

3. The number of bolts for fixing the lamp holder should not be less than the number of fixed holes on the lamp holder, and the bolt diameter should be matched with the hole diameter; the lamp holder without fixed installation holes (self-drilling during installation), each lamp for fixing bolts or screws should not be less than 2, and the center of gravity of the lamp should be consistent with the bolt or bolt center of gravity; When the diameter of the insulation stand is below 75mm and below, only 1 bolts or screws can be used.

4. Nordic Minimalist Lighting can not be installed directly on combustible objects. Some families use three splints lined with Nordic Minimalist Lighting for the sake of beauty. In fact, this is very dangerous. Thermal insulation measures must be taken. If the high-temperature part of the luminaire surface is close to combustible materials, thermal insulation or heat dissipation measures should also be taken.

First: when you install, please make sure that the power supply is off, or that the reserved wires in the place you need to install are not powered! Otherwise, life is safe!

Second: The two terminals connected to the Nordic minimalist lighting power supply should have good electrical contact, and should be wrapped in black tape separately, and keep a certain distance. If possible, the two terminals should not be placed under the same piece of metal to avoid short circuit and danger.

Third: If the Nordic Minimalist Lighting uses a spiral head, then its wiring should pay attention to the following two points:

The phase line should be connected to the terminals of the center contact, and the zero line should be connected to the terminals of the thread.

2. The insulation shell of the lamp holder should not be damaged and electric leakage, so as to prevent electric shock when changing the bulb.

Fourth: rooms with higher floors or vibrant ceilings are suitable for installation of Nordic minimalist lighting. When installing Nordic minimalist lamps in masonry structures, pre-embedded bolts or expansion bolts, nylon plugs or plastic plugs shall be used; wood wedges shall not be used. And the bearing capacity of the above fixings should match the weight of the Nordic minimalist lighting. To ensure that North European minimalist lighting is firm, reliable and can extend its service life.

Fifth: When using expansion bolts to fix, bolt specifications should be selected according to the Nordic Minimalist Lighting Dimension product technical requirements, and the drilling diameter and buried depth should be in accordance with bolt specifications.

Sixth: Installation of special lighting fixtures and installation of the reliability of the connection must be able to withstand the connection of the lamp equivalent to 4 times the weight of the hanging without deformation.